|
129 results found
|
displaying 16-18 |
|
|
| Waffled Icecream 
It's been a craving of mine for the past... few months. My favorite part of ice cream is the cone. And I'd eat just the cone, but it doesn't taste right without the ice cream. Idea: Ice cream that is "waffled" into a cone. (I'm calling it "waffled" because it'll be in a waffle cone, not because it'll be like a filled waffle.... which it kind of will be. So that's okay.) But it wouldn't be too thick, so it could be easy to eat. Look: It'd look like a plain flat-like space ship. The outside: waffle cone. The inside: chocolate layer on the direct inside of the cone. Then a layer of ice cream. Then a thin layer of cone (for extra crunch purposes.) Then a layer of ice cream. Then the bottom cone. Kind of simple right?Size: Not too big. If it took to long to eat, the ice cream would melt, and make a big mess. Which is no good. About the width of a hamburger. And a little higher than a crunch wrap supreme.
(The thin layer of cone in the middle could kind of mimic the hard taco shell in the middle of a crunch wrap supreme.)Flavors: All kinds! It could be an entire business. Every type of ice cream. And nuts, fruit, whatever could be thrown in.Reward: A mint chocolate waffled ice cream. 
There are 2 replies to this idea
|
|
|
|
|
|
|
| Food-holding Bib
This is simply a bib that includes a space to hold some food. You could also add a cup holder for it to hold beverages. Care would need to be taken to avoid spills, especially when a person bends down (the bib should swing from the neck). Also consider how it would fit on ladies. Even small breasts could interfere with the fit.I think this could be made at home with a food grade plastic container if it is large enough and has one side that is flat and reasonably wide. You would just cut it up leaving the wide flat side and two or three inches of the bottom intact (side cuts should be a 45 degree angle down and away from the bib to prevent bending between it and the bowl). Then make holes for a rope at the top and thread it through and knot it at the ends to make the part that would hang over your head (make sure it's big enough to fit). You could bolt together the sides of several containers for a wider bib with more than one compartment.This would be great to hand out to guests at parties. You could have people wear different dips and approach each other to try some. It could really cut down on the need for space on a buffet table too.Reward: Post an instructable explaining how to make on one and where to find the containers
Post a reply to this idea
|
|
|
|
|
|
|
| Smart Water Fountain
I'm thinking of creating a water fountain for a school or a company that when you walk up to it, it can automatically start dispensing about 250ml of water to the employee or student. This would be possible by rfid scanner built into the water fountain which collaborates with the employee's id or student id. If the user would require more water, then they would pass their id over the sensor. I also want to add the feature of a database which records the amount of water a user would drink, and email or sms them via bluetooth encouraging them to drink more water based on how much they would drink. Added to this is a component which checks the amount of water that would be dispensed so that a message can be sent to the maintenance department informing them that the filter needs changing. It therefore means that only students or employees would have access to the water fountain. If a visitor is in the building or school I'm saying they should have a visitor pass which would have the technology built into that card which would give them access to the water fountain.What do you think?Reward: Ease of use, and recording keeping of the amount of water used. On time changing of the filter.
Post a reply to this idea
|
|
|
|
|
