|
| Shingle Sheets
Imagine shingling your house in one half hour, rather than back breaking labor for days. If you were to place hundreds of shingles on one large sticky roll and have it crane lifted to the top of the house and simply stick the shingle sheets covering the entire roof, then you would have a very fast and efficient way to shingle a house. It would also not leak, because it couldn't be lifted by the air or any outside conditions of weather. It would also have no break in between shingles, and there for would seal the entire roof. The only tool needed to complete the very fast process is a utility knife, which would be used to cut off any extra shingle material on the edges of the house. It could look like a regularly shingled house, or it could be more designish and you could add any logo, design, pattern, look, or even cartoon characters. It would be cheaper to make, and even more cheaper with hardly any labor cost!Reward: Credit
There are 3 replies to this idea
|
|
|
|
|
|
| Small Scale Desalination Dome
There are many types of solar powered desalinators being suggested, some even patented, but the one I am considering should be cheapest to build and run for very small scale or local uses, and easiest to use in areas of strong sunlight and salt water supply, such as coastal areas or brackish lakes.Design:A dome of clear material is placed over a pool of saline water, such as on a quiet coastal strip or brackish lake. The edges of the dome are submerged to several inches but is open underneath.Inside the dome a mat black ceramic tile is placed angled so the flat facing is towards the prevailing sunlight direction. At the top of the dome a tube is connected and is angled towards the ground some distance away. At the other end of the tube, preferably below ground level, is a cooling radiator, and collection sump. These are protected from the sun but, like a weather station may be open to the winds. The radiator extends upwards and projects a couple of meters above the ground level to catch the winds.At the opening to the tube, just at the top of the dome, is an impeller or fan, which is connected to a small fan on the outside of the tube.The impeller is also connected to a small pump and tube inside the dome, behind the ceramic plate, that takes water from the saline pool and discharges onto the top of the tile.Operation:Sunlight heats up the air in the dome and the black ceramic plate until it becomes hot enough to boil a thin film of water passing across its surface.A combination of winds on the external fan, and internal pressure increase from the heated air within the dome, turns the impeller and activates the pump to pump a small amount of salt water up the pipe and discharges it across the face of the ceramic tile.As the water on the tile evaporates into steam, the increased pressure drives the impeller in the tube and pumps more water onto the tile. The flow of water on the tile washes away any salt residue to keep the tile clean.Steam from the dome flows down the tube from the impeller to the cooling radiators, held below ground level or protected under a cover. Winds, and the effect of cooler temperatures at sub-ground levels, condenses the steam which collects in the sump, ready for collection or piping away for use. Excess heat is lost to the atmosphere through the elevated radiator surfaces.By being open ended at below the water surface the design allows the concentrated saline to flow away from the dome, whilst the salt water level keeps a pressure seal for the domes atmosphere to heat up and expand through the tube and impeller.
Post a reply to this idea
|
|
|
|
|