- Sat Dec 15, 2007 3:03 am
#13551
Thanks again Bill, you are a fountain of knowledge on the subject at hand, probably others as well. That guess about my next question did however, turn out to be incorrect. As per your provided info, I am dealing with thousands of approximately 100,000 volt arcs. I think my next questions will be quite difficult. First, I can force all of the arcs to the same piece/length of wire/conductor. The question, Is the energy dissipated in the arc and pop? Or, is there an accumulation and current along the wire. Next question, if I close the distance between the wire and the generating surface, perhaps even to contact the generating surface. Can you hazard a guess as to my possible consequence?
I realize that real world tests may be needed to answer the second question. But I will know more after you respond.
Best Regards,
Tom.
I realize that real world tests may be needed to answer the second question. But I will know more after you respond.
Best Regards,
Tom.