The main tank, brimful with ideas. Enjoy them, discuss them, take them. - Of course, this is also the #1 place for new submissions!
By mtd28student
Motorised skate boards have been around for a while. Basically they are snowboard sized skateboards with 40ish cc engines on the back of them, usually chain or belt driven the back wheels. This is fine, but these monsters can't really be used on or at a skate park. Because of the size and the weight of them, it is impossible to do tricks with them.

What i am thinking about is a motor that is attached to the back of an ordinary skateboard, but it is detachable. So once you get to the pack, you simply undo the fasteners and pull it off.

You want to be able to attach the device to any skateboard, so a means of propulsion needs to be thought of that doesn't include the skateboards wheels (jet propulsion isn't really an option either).

A swing arm out the back of the skateboard would probably do the trick. The swing arm would have a single rubber wheel on it and be spring loaded so that it is always in contact with the ground. The wheel could be belt, chain or shaft driven.

And the engine could be either electic or petrol (chainsaw for prototype). Electric posses the problem of batteries and petrol posses the problem of weight.

I started to make a prototpe of this (many moons ago, when i was about 14) but the centrivical clutch broke on the engine and i never got round to finishing the project.

any improvements anyone?

Reward: once in production..... a discount
User avatar
By Michael D. Grissom
Cox .035 to .065 model airplane engine into a model airplane screened ducted fan clip mounted at the rear of the skateboard and a half pound of fuel should get you anywhere you want to go and back. Use a model airplane remote (wireless) engine control to adjust power accordingly. I used two .035 engines strapped to each side of my bicycle handlebars to travel everywhere when I was about 10 years old. I am now old enough to realize that I am extremely luck to be alive! Be sure to use the protective screens.

Water Bed Chairs And Couches Etc.

I used to have a kidney shaped water couch and it […]

Bath body hair removal

I think a whirlpool with the chemical in it would […]

Is there anymore need for physical cards? I suppos[…]

A Place for problems and solutions

This is a really good proposal. One title could be[…]