Submissions that have been rejected by the Creativity Pool. - The Docks aren't necessarily the final destination, if a broken idea gets fixed it may travel to a more appropriate category.
By TomT
#23620
Have tried many bed-sheet holders and almost all are useless or complicated. This system involves removing the mattress and then turning it so may not be ideal for frail people or 7-stone weaklings !
The holder consists of a strong 4" wide and 4'long fabric strip with 8 elasticted pairs of arms about 12" long. The arms are attached securely at top/bottom 45 degress angle to secure the sheet corners and at 16" and 32" to secure the sides. Each of the pairs ends in a 1/2" male/female fabric-covered press stud.
Method - Remove mattress from bed and spread out new sheet,place mattress on top of sheet and pull all 4 sides over,attach arms by sliding one strip underneath the sheet and pressing the stud on the other strip. The sheet should be firm but not too tight to avoid damage,the press-studs are covered for the same reason. When finished with all 8 arms turn the mattress over. I have not been able to find anything like this online but would be surprised if it has not already been "invented"

Tom.

Reward: I would love one of these,the clips that I am presently using are difficult and time-consuming to attach/detach.
OFFSHORE

Is there anymore need for physical cards? I suppos[…]

A Place for problems and solutions

This is a really good proposal. One title could be[…]

Team Innovating Forum

Are there forums for team innovating? Normally peo[…]

Whats your favorite Xbox game?

Mine is outrun2